I helped a friend with her Halloween themed wedding and last minute I decided to make a flower bouquet.
I love how it turned out!
I used the leftover black roses and skulls from the table centerpiece decorations.
Purchased a strofoam half ball at Micheal's craft store.
I had leftover black styrofoam safe spray paint from a previous Halloween craft.
Used black 1 1/2 inch satin ribbon for the handle.
I spray painted the half ball black and cut the roses off the vine. I also removed the leaves but ended up only using the roses.
I didn't have a dowel wide enough so I cut down a PVC pipe from my zombie skeletons.
The leg...lol!
Hot glued a piece of ribbon over the bottom.
Used the PVC pipe to twist a hole in the center of the half ball.
Removed the center.
Used lots of hot glue to attach the PVC pipe into the bottom of the base.
I cut 7" strips of ribbon to cover the bottom of the base.
Hot glued to make loops.
Attached the ends with hot glue to the PVC pipe. Make sure you leave enough so the loop goes all the way to the edge of the base.
Hot glued to attach the loop to the base.
Repeat until bottom of the base is covered.
Start at the bottom of the PVC pipe and wrap the ribbon towards the bottom of the base.
Wrap a little and hot glue, wrap a little more and hot glue. Repeat.
Once all the ends of the loops are covered, cut the ribbon. Fold the end and hot glue in place. This will give it a clean edge.
Ready to start decorating.
I placed all the roses in the styrofoam first for spacing. Once I had it figured out, removed and hot glued in place.
The skulls were too thick and stuck out past the roses.
I decided to cut the skulls in half with an exacto knife.
Hot glued the skull in place.
Added more roses.
And more roses.
I thought about adding more skulls but it looked too busy. I ended up only using four with the rest roses.
I love that it matches the table centerpieces.
You might also like:
Thank you for visiting my blog. Any questions? Just ask!
Follow me!
